Sapphire Blue Anodizing Dye DYEFBGN8 Small

Fast Blue GN Anodizing Dye

Also Called

Sapphire Blue Anodizing Dye

Part Number: DYEFBGN8    

The dye supplied is c.32gms allowing for a makeup of 8 litres at 4 gm/L

1. Description

Specialty Fast Blue GN is a single component, water soluble dye, used to color anodized aluminum sapphire blue.

2. Application instructions

Concentration: 3-4 g/l pH: 5.5 ±0.5 

Buffering: Not required 

Temperature:  60°C ±2°C. 

Oxide film thickness: 0.30 mils. or greater 

Dye time: Depending on the shade desired, dye times could range from 5-15 minutes, but can only be determined by sampling in production. 

Preferred sealing:  Caswell Sealant

3. Conditions for using Sapphire Blue, or Fast Blue GN Dye

Tank: Stainless steel or other acid resistant materials such as neoprene, polyethylene and polypropylene that can withstand a constant operating temperature of 60°C

HDPE buckets are supplied in Caswell Australia's Anodizing kit.

Water quality: Distilled or Deionized.

pH adjustments: Raise with sodium hydroxide. Lower with acetic acid. The pH should be checked once per shift for commercial or heavy users, with a calibrated meter and maintained within recommended range.

Bath agitation: Moderate agitation must be used for high uniformity of color.

Rinsing: It is important to remove all acid residues clinging to the work and acid retention in the oxide pore itself. Rinse work load thoroughly after anodizing. A minimum of two rinses is recommended, with the second rinse at over-flow. To increase rinsing effectiveness, add vigorous air agitation in all rinse tanks. This also improves your rinsing of surfaces on complicated shaped parts.

Precaution! This dyebath is very sensitive to drag-in of the anodizing electrolyte. Effective rinsing and care to eliminate drag-in are suggested for optimum tank life.

4. Light fastness

Rating: 8 (1=poor, 8=excellent) This color is suitable for outdoor applications BUT the dying should be on 0.8 mils and the concentration of the dye should be increased to 5 - 7 gms/L. the time should also be extended to 20 - 30 minutes.

5. Storage

Shelf life is virtually unlimited. Store in original container in a cool dry location. Close package tightly after removal of dye if you are not going to use the full amount. In humid environments, dye powder may clump-up.

6. Preparation of a new dyebath

1. A cleaned tank is filled with deionized water to about 75% of final volume and raised to dyeing temperature.

2. The required amount of dye is weighed out and dissolved in hot deionized water (71°-82°C) in a separate container until a slurry is formed. This is your stock solution.

3. With agitation turned on in tank, pour stock solution into tank.

4. Top off the tank to final working solution volume with more hot deionized water and agitate for 15 minutes.

5. Using a calibrated pH meter, check the pH and adjust if necessary.

6. The dyebath is brought to dyeing temperature, 60°C ±2°C.

7. Product safety We recommend that the company/operator read and review the Material Safety Data Sheet for the appropriate health and safety warnings before use.


See below for current MSDS

Price: $25.00


Your opinion is important to us...tell us what you think!

Review This Product

Additional Information

Product Data